LaserSoft Imaging IT-8 Target extended middle format set
The Lasersoft Imaging extended middle format set consists of the two individual products advanced trancparency 6x7cm Fuji target and resolution target. With this set you can calibrate a film scanner and measure its resolution.
You can find detailed information about IT-8 colour calibration and colour management on our SilverFast website and colour management website.
You can find detailed information about determining the effective resolution with the USAF-1951 test chart on our website about resolution of film scanners.
Benefits of LaserSoft Imaging IT-8 targets
- Higher precision than other manufacturers because smaller units are produced and calibrated
- Significant higher dynamic range
- A barcode on the target enables automatic detection of the according reference file (LaserSoft Imaging patent)
Scope of delivery
- LaserSoft Imaging advanced trancparency 6x7cm Fuji target
- LaserSoft Imaging USAF 1951 resolution target as framed 35mm slide
On this page we introduce recommended accessories for IT-8 targets:
Before carrying out an IT-8 calibration with an IT-8 target the target should be cleaned in order to avoid wrong measurements. The easiest way is simply brushing the film holder with an anti static brush, which not only removes the dust but also removes electric charges. Discharging is important because electric charge adducts dust as is generally known. Kinetronics anti static brushes are available in different sizes.
|
When working with film strips it often happens that you accidentally touch the emulsion side of the film. The damage often is irreparable. You can avoid damages to the film material and comfortably insert film strips into the scanner or film holder by wearing fine cotton gloves.
|
Anti-dust spray is used to clean film material - no matter if it's mounted slides or film strips - by removing dust and fluffs with a flimsy current of air without touching the film material at all. There is no better, more comfortable and more efficient way to clean your film material. Additionally anti dust spray is suitable to clean the scanner from dust thus avoiding disturbancies in the scans.
|
For working with single negatives or positives or film strips we highly recommend using tweezers with flat shovels, because otherwise you run the risk of touching and damaging the film. Additionally, with such tweezers you easily take out film strips from archive sheets or photo bags.
|
.jpg "Preview: Kinetronics anti static brush SW-020")
