Reflecta LED light pad A5 19x14 cm dimmable
The new reflecta light panel A5 has a viewing area sized 190 x 140 mm, so that 6 mounted 35mm slides can be viewed at the same time. The LED lamps provide consistent illumination of the viewing area, which means that also the border areas can be used for viewing transparencies.
With the help of the reflecta Light Pads one can correct pictures, enhance sketches or monitor animation drawings. Small picture slides, stored in archive sleeves, can be viewed on the Light Pads without having to remove them from their casing. The Light Pad is an important device in printing, as well as in film, photo and tattoo studios. It can be used to place transparent material such as films or tracing paper over each other, fixate and then edit them.
While a hobby photographer may hold up a slide to the light, the professional or semi-professional photographer will use a Light Pad to view his material. For those who use film material (slides and negatives) or all types regularly, they will not get around the use of a light pad.
The sleek design is creditable - this light panel integrates very well in a modern working environment due to its very low thickness.
You can find further information and a shopping guide for light panels on our website about light panels.
Specifications
- Viewing area: 19 x 14 cm
- Adjustable illumination (dimmable)
- Light source: LEDs
- LED lifetime: approx. 50.000 hours
- Power supply: Adaptor DC 3,5mm 12V 4.3W
- Weight: approx 400g
- Dimensions: 23.9 x 18.9 x 0.8 cm
Scope of delivery
- Light pad A5 Super Slim
- Power adaptor
- User manual (German, English, Polish, Dutch, Portuguese, Spanish, Italian, French)
On this page we present recommended accessories which help you a lot at your work with the light panel.
Â
Â
For the cleaning of the glass surface of the light panel we recommend the scanner cleaning set from Kinetronics. The set consists of an anti static cloth, with which you can clean the complete glass surface, and an anti static brush for cleaning smaller parts, but also for cleaning film material. Both the cloth and the brush have the special feature that they remove static charges, which adduct dust magically.
|
If the glass surface of the light panel is covered with strong dust we recommend the use of the Kinetronics cleaning fluid PLCD. That's a high value cleaning fluid, which has been developed especially for the cleaning of optical glasses and glass surfaces. With a couple of drops you can effectively remove dust and dirt.
|
When working with films it often happens that you accidentally touch the emulsion side of the film. The damage often is irreparable. You can avoid damages to the film material and comfortably put films onto the light panel by wearing fine cotton gloves.
|
Anti-dust spray is used to clean the glass surface of the light panel by removing dust and fluffs with a flimsy current of air without touching the glass surface at all. There is no better, more comfortable and more efficient way to clean your light panel. Additionally anti dust spray is suitable to clean film material.
|
For working with single negatives or positives or film strips we highly recommend using tweezers with flat shovels, because otherwise you run the risk of touching and damaging the film. Additionally, with such tweezers you easily take out film strips from archive sheets or photo bags, and you can easily put them onto the light panel.
|
reflecta GmbH
Merkurstraße 8
72184 Eutingen
Tel.: 07457-9465-60
Support: 07457 9465-887
E-Mail: mail@reflecta.de
Merkurstraße 8
72184 Eutingen
Tel.: 07457-9465-60
Support: 07457 9465-887
E-Mail: mail@reflecta.de
